Zeck Audio STAC Force180 Guía de instalación descargar pdf (Pagina 9)

Rev. 1.00 12-02-13 9/41

On 6.T releases the Message-Waiting-Indication on FXS ports was not working anymore. This

has been fixed.

11860 SIP re-register not working

The SIP header “received” and “rport” parameters were handled incorrectly in an incoming SIP

packet. This behavior caused the SIP stack to keep the old registration. Now these parameters

are handled correctly and a proper re-register will be initiated in this scenario.

11879 ADSL annex A/B/M

This software build supports the new SmartNode models with the new ADSL interface. In

addition it is now possible to setup an ADSL connection in an easier and more flexible way. The

connection can be configured both with annex A/B and M. PVCs with PPPoEoA, IPoEoA,

PPPoA and IPoA are concurrently supported together with LLC and VC encapsulation. Refer to

the section New Configuration Commands for a detailed description.

11888 Improved dial „on-caller-id‟ on FXO

The „ring-number‟ command in the FXO interface has an option „on-caller-id‟, which is meant to

establish the call as soon as a caller-ID was received. This worked only when the caller-ID was

sent mid-ring. When the caller-ID was sent pre-ring the call was established after the second

ring-burst. This has been changed now in such a way that when the caller-ID was received pre-

ring the call is established after the first ring-burst.

11908 Layer 2 COS for PPP and PPPoE control packets

Layer 2 COS is now set to 7 for PPP and PPPoE control frames, when these packets are

encapsulated in IEEE 802.1Q tagged frames. If needed, the user can configure this layer 2

COS to another value (from 0 up to 7) using a new command in the PPPoE session.

This new feature allows traffic prioritization of PPP/PPPoE packets and adds a way to provide

best effort QoS or CoS at layer 2.

Refer to the New configuration commands section for further details.

11935 Administrator login to administrator exec mode

A new configuration command allows users with administrator privileges to be logged directly

into the administrator exec mode which is otherwise entered with the command “enable”. Refer

to the New configuration commands section for further details.

11937 MWI Subscription failing

Caused by a software bug the contact address in SIP Subscription messages was containing

an unnecessary trailing comma character. This has been fixed in the current software release.

11940 H.323 Call Resuming

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 40 41

Sin comentarios

Zeck Audio STAC Force180 Guía de instalación Pagina 9